syed ali raza

Innovative Engineering Solutions (M.E.P)  June ‘ 22 – Present
Design Engineer – Electrical
 Designing of HT & LT side power schemes for High-Rise buildings , Health facilities ,Mix-used &
Apartment buildings.
 11 KV Equipment and substation designing which includes HT Panels, Consumer panels ,ATS ,Sync
panel ,bus bar and Earthing system for different projects.
 Designing schematic layouts for ELV systems such as Public address ,CCTV , Telephone & Data
communication and Fire alarm system for buildings.
 Preparing the BOQ’s & Engineer’s Estimate for all kind of projects regarding electrical scope of work.
 Design of LT switch gear, distribution boards, control panels and Meter-Panel Boards for supply and
energization of the system.
 Designing of ACP panels for HVAC load and providing single line diagrams for load divisions.
 Complete load calculations with demand load and diversity factors as per area requirements,
specifying common & critical loads.
 Balancing three phase loads for the system and avoiding unequal division of system.
 Preparing panel schedule ,cable routing along with voltage drop calculations .
 Sizing of transformers and generators according to the load requirements .
 Designing Protection scheme with protection devices for the equipment and the system.
 Development of specifications for Electrical Equipment
 Testing and Commissioning of Transformers, Generators & Switchgears.

VAROW International, Pakistan 

Associate Design Engineer – Electrical
 Designing of MV, LV and ELV systems including Riser diagrams.
 2D drafting on AutoCAD for all layout plans.
 Preparing the BOQ’s for the projects and providing the most economical budget for the projects.
 Preparing the financial comparatives for the client , providing best satisfactory rates in the market.
 Identifying problems and flaws in the design, planning and re-designing.
 Lux calculation for lighting using DIALux for different lighting schemes and scenarios .
 Load calculation for different types of loads i.e. commercial, residential and apartment buildings.
 Contacting vendors for all types of products and providing designs according to the specifications.
 Calculating wire sizes and breaker sizes for different loads and suggesting protection equipment.
 Coordination & meetings with the client and the contractors .
 Site supervision of installation of Electrical works, inspecting the quality of the material & comparing the
design drawing.

Bachelor’s in Electrical Engineering (Power) – University Of Lahore

CGPA:3.04

 Power distribution & Utilization 

 Power system protection
 Power system analysis

  Power transmission line